Drag Racing Discussions > Front Engine Dragsters
SET UP ON REAR GEARS
hemidakota:
Well we had a great time at CHRR for sure until spool let loose of all left axle splines. So my question is on setting up gears. Does everyone set gears up just like any other set of gears? Or do you shoot for a tighter backlash with a good pattern or just perfect pattern? Thanks for input as usual.
GlennLever:
--- Quote from: hemidakota on October 21, 2014, 12:36:57 PM ---Well we had a great time at CHRR for sure until spool let loose of all left axle splines. So my question is on setting up gears. Does everyone set gears up just like any other set of gears? Or do you shoot for a tighter backlash with a good pattern or just perfect pattern? Thanks for input as usual.
--- End quote ---
Try posting this here, Dan Dishon's Transmission Den
http://www.frontenginedragsters.org/forum/index.php?board=36.0
masracingtd1167:
--- Quote from: hemidakota on October 21, 2014, 12:36:57 PM ---Well we had a great time at CHRR for sure until spool let loose of all left axle splines. So my question is on setting up gears. Does everyone set gears up just like any other set of gears? Or do you shoot for a tighter backlash with a good pattern or just perfect pattern? Thanks for input as usual.
--- End quote ---
Was it an alluminum spool ?
dreracecar:
Been running the same alu spool and 31 spline axles for since '91, last time I checked it was '95, Blown alc 7-0Pro
hemidakota:
Yes it was a 31 spline axle and alum spool
Navigation
[0] Message Index
[#] Next page
Go to full version