Author Topic: Alcohol fuel system maintenance between races  (Read 10024 times)

Offline arush

  • Jr. Member
  • **
  • Posts: 59
    • View Profile
  • Your Engine: Blown-Alcohol-Injected 427 BBC
  • Your Track: Thompson Raceway Park
  • Your Vehicle: King Chassis 160" FED
  • General Location: Pa.
Alcohol fuel system maintenance between races
« on: March 16, 2017, 01:26:02 PM »
I plan on starting my (first) Hilborn 4 port alcohol injected, blown BBC within a couple of weeks.
What is the proper procedure at the end of a race day to clean out the fuel system besides draining fuel tank and lines.
Is it OK to install a set of old plugs and let it run on gas for a few seconds ?
Since I will only be attending limited events, the digger could set for a few weeks before getting it out again.
As always, I appreciate all responses.   

Offline THE FRENCHTOWN FLYER

  • Sr. Member
  • ****
  • Posts: 360
    • View Profile
  • Your Best Time: 8.28@168 door; 9.00@147 6-cyl alt; 8.53@160 RED
  • Your Engine: 300 Ford six NA w/ crossflow and prod. heads
  • Your Track: Milan, Thompson
  • Your Vehicle: (3) Advanced Chassis altered , The Last Logghe altered, '30 RPU
  • General Location: North Coast
Re: Alcohol fuel system maintenance between races
« Reply #1 on: March 17, 2017, 06:50:26 PM »
While I don't have a blown BBC on alky, a fellow racer at my track runs an alcohol RED and he has a separate gasoline system on the car to make it easy to start, put heat in the engine, and drive it up to the staging lanes. You may want to consider something similar?

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
Re: Alcohol fuel system maintenance between races
« Reply #2 on: March 18, 2017, 06:45:20 AM »
Here is what has worked well for me

Next day after home from the race I  warm up and drain oil and change filter--then I take lines loose--force air through return line then a shot of WD40 and blow some more--then same through vent line which clears main line--then WD40 down the tubes and in main feed line --open barrel valve and force air and WD40 through--open/close fuel cut off while adding WD40 or a little oil--with all lines blown out I reconnect them
Pull spark plugs--WD into each cylinder and turn engine a little--plugs back in.
Adjust valves as needed     
The WD40 is not ideal   when you service your stainless filter elements there will be small "dumplings" of WD40 I guess
It has never hurt anything and I have had Zero issues over about two years now doing it this way
The WD down the tubes and a spin after last run of day is important to keep cylinder walls from rusting
I think a Toplube helps keep the system in better shape than without but use less not MORE than they say
I have always had a fascination with fast cars at the expense of more normal character development

dreracecar

  • Guest
Re: Alcohol fuel system maintenance between races
« Reply #3 on: March 18, 2017, 08:25:55 AM »
WD drys out the o-rings --good to keep spares in the tool box for the BV and fuel shutoff

Offline AF150

  • Jr. Member
  • **
  • Posts: 92
  • The Devil is in the Details
    • View Profile
  • Your Best Time: 7.37 1/4 mile
  • Your Engine: Early Hemi, 365", Blown Alky
  • Your Track: Tulsa Raceway Park
  • Your Vehicle: 200" FED
Re: Alcohol fuel system maintenance between races
« Reply #4 on: March 18, 2017, 09:16:05 AM »
Here is another routine that we have been using for many years...
Drain the tank and all supply / return lines. Mix up a batch of ~ 70% gasoline and
30% motor oil. Remove all spark plugs. Take the line from the shut-off valve to the
barrel valve loose at the shut-off valve. With air compressor on and a helper standing
by (was usually my wife) fill the line to the barrel valve with gas/oil. Also apply mix
to the pump thru open shut-off valve. Have the helper spin the engine and open the
throttle as you force the mix thru the whole system with compressed air.( Don't stand
in front of the spark plug holes.) This cleans and lubricates the the whole fuel system
and the top-end of the engine. Might put more mix in the pump and turn engine backwards just to make sure all alcohol is removed and pump is well lubed. Dry the
tank and other lines with compressed air cause you don't want to leave alcohol sitting in anything, especially anything aluminum. Replace spark plugs and lines.

Next time you warm-up the engine, all the mix will disappear and you will pass fuel
check if that is a class requirement. Running upper-lube in your alcohol may not.

MB
MB

Offline arush

  • Jr. Member
  • **
  • Posts: 59
    • View Profile
  • Your Engine: Blown-Alcohol-Injected 427 BBC
  • Your Track: Thompson Raceway Park
  • Your Vehicle: King Chassis 160" FED
  • General Location: Pa.
Re: Alcohol fuel system maintenance between races
« Reply #5 on: March 18, 2017, 06:16:09 PM »
Great suggestions.
Appreciate the feedback.

Offline JrFuel Hayden

  • Hero Member
  • *****
  • Posts: 600
    • View Profile
    • Hayden Enterprises Speciality Wheels
  • Your Best Time: 6.02, 236 mph, 1/4 in 1973 Div 3 TF Champ
  • Your Engine: SBC, Alky, 403 ci, Best 6.99 @ 190 & 409 Hemi
  • Your Track: Bakersfield
  • Your Vehicle: 225" FED NHRA Heritage Jr Fuel
Re: Alcohol fuel system maintenance between races
« Reply #6 on: March 19, 2017, 02:12:08 AM »
this is what we have been doing for the last 18 years after every race event, and never had a problem with nozzles, etc; drain the fuel tank, and fuel line from tank to fuel pump, blow it out and let air dry until getting ready for next event, blow out fuel pump, clean with brake clean blow-out again and put Marvel Mystery oil turn over by hand and put it a plastic bag, blow out fuel shut off , brake clean, plastic bag, take out the fuel nozzles, blow out, clean with brake clean wrap in plastic bags, blow out clean with brake clean barrel valve and wrap the nozzle hose ends in plastic. This what has been recomended when we 1'st started racing the JF car by Bob McKray, race engine builder, engine builder and tuner for Don Enriquez Jrfueler, Don still works for Hilborn, and also recomends this cleaning process and Gene Adams, who now flows and sets-up fuel systems after working for Hilborn.
 Mike this might be more or less work or time than your 70-30% gas/oil, but we have never had a pluged nozzle, because of the corrosion that can happen with alky. I have helped crew on a comp racer for years and they would not use clean their fuel system, mostly because they raced often at Division and national events, so they would have little down time, BUT, would have crystals in the Kinsler nozzles from time to time.
We can't use WD-40, because it will cause the fuel to fail the  fuel checks, as will top oiler, and alky with top oiler, like VP M-3, and of course VP M-5 that has nitro in it.
We also drain the engine oil and filter after each event, of course looking for metal, and also because alky attracts water, and you have alky in the oil from the rings, so we dont want a rusty iron block after sitting for awhile.  BTW, don't leave alky jugs open,or fuel tanks, it attracts water.
I hope this helps guys
Jon
Jon C. Hansen

Hayden Wheels

dreracecar

  • Guest
Re: Alcohol fuel system maintenance between races
« Reply #7 on: March 19, 2017, 11:14:05 AM »
Hilborn nozzles have micro screens inside and tend to get gunked up more than Enderle's which are just a straight drilled hole sprayed against a flat surface to atomize

Offline Curly1

  • Sr. Member
  • ****
  • Posts: 260
    • View Profile
    • AireTex Compressors
  • Your Best Time: 7.95 @ 167 1/4 mile
  • Your Track: Texas Motorplex
  • Your Vehicle: 125" Altered
Re: Alcohol fuel system maintenance between races
« Reply #8 on: March 19, 2017, 06:19:37 PM »
I have ran alcohol since 1998 and do not do much special. I do use top lube get motor good and warm to evaporate moisture out of oil before I put it in trailer. When I set up system I made sure everything was compatible with alcohol.

Offline JrFuel Hayden

  • Hero Member
  • *****
  • Posts: 600
    • View Profile
    • Hayden Enterprises Speciality Wheels
  • Your Best Time: 6.02, 236 mph, 1/4 in 1973 Div 3 TF Champ
  • Your Engine: SBC, Alky, 403 ci, Best 6.99 @ 190 & 409 Hemi
  • Your Track: Bakersfield
  • Your Vehicle: 225" FED NHRA Heritage Jr Fuel
Re: Alcohol fuel system maintenance between races
« Reply #9 on: March 19, 2017, 07:10:44 PM »
Curly, so you don't clean the alky out of your system between races ? And never had a pluged nozzle, never seen anything that looks like salt , alky corrosion ?
BTW sprint car engine guys suggest top oiler because their race cars are on the throttle a whole lot longer than dragsters, and need more valve and valve guide lube.
The Jrfuel racer that had a rusty block had left his oil in the motor after racing for his winter, maybe 3 months.
Also, when we 1'st get to the track we plug in an oil pan heater, and spin the motor with-out plugs to get oil pressure up and watch for fuel coming out of the plug holes, then we know the oil is up and the fuel system is purged.

Jon 
Jon C. Hansen

Hayden Wheels

Offline Curly1

  • Sr. Member
  • ****
  • Posts: 260
    • View Profile
    • AireTex Compressors
  • Your Best Time: 7.95 @ 167 1/4 mile
  • Your Track: Texas Motorplex
  • Your Vehicle: 125" Altered
Re: Alcohol fuel system maintenance between races
« Reply #10 on: March 23, 2017, 07:10:50 PM »
No Sir, I have never had any problems. I say that as I am having a problem now but I think it is a fuel supply problem and I had also made a bunch of changes in fuel system in off season so right now can not say for sure. Car is flat running out of fuel and laying over. Data logger has verified it but I am not sure I have resolved the issue yet.
I did drain the fuel and change the oil for the Winter but during season nothing special except get motor good and warm before I load it into trailer.  And first two test and tune days was decent but not quite where I need it to be, third TnT it was terrible.

Offline nostalgic371

  • Newbie
  • *
  • Posts: 26
    • View Profile
  • Your Best Time: tbd
  • Your Engine: none
  • Your Track: none
  • Your Vehicle: none
  • General Location: socal
Re: Alcohol fuel system maintenance between races
« Reply #11 on: March 23, 2017, 08:45:03 PM »
Out of the different oils to consider for Alky injection maintenance; WD-40, can dry out O rings, ATF, can make O rings swell up, Marvel Mystery, good stuff, but can gum up a bit if it sits for a long time, another oil to consider might be a good quality air tool oil, it's anti corrosion and moisture, contains a solvent to act against gum, and lubes tools meant to maintain tight clearances, which seams similar to an injection pump.

Just my 02

There is also a marvel mystery air tool oil as well.

Offline glofria

  • Full Member
  • ***
  • Posts: 138
    • View Profile
  • Your Best Time: 7.323 @ 185.05
  • Your Engine: A blown 388 c.i. Small Block Chevy
  • Your Track: Auto Club Famoso Raceway
  • Your Vehicle: An original 1957 Chevy Bel-Air
  • General Location: Southern California
Re: Alcohol fuel system maintenance between races
« Reply #12 on: March 24, 2017, 10:29:11 AM »
We use Justice Brothers JB-80 to lubricate all the lines and cylinders when the car is not running.


Offline JoydayVox

  • Full Member
  • ***
  • Posts: 179
    • View Profile
    • dapoxetine uk muscle
  • Your Best Time: Urenulo
  • Your Engine: Ekubyboxe
  • Your Track: Ysehekol
  • Your Vehicle: Ijesu
  • General Location: Eweciq
Re: Alcohol fuel system maintenance between races
« Reply #13 on: November 18, 2024, 04:28:07 AM »
priligy dapoxetine buy The Mahmud group provides in vivo evidence to show that the acetylation at 25 OH occurs prior to the methylation at C 27