« previous next »
Pages: [1]   Go Down

Author Topic: Seat Buckets / Pans  (Read 5474 times)

Offline PSweeney

  • Full Member
  • ***
  • Posts: 231
    • View Profile
  • Your Track: Santa Pod
  • Your Vehicle: 138in SBC slingshot
Seat Buckets / Pans
« on: October 08, 2014, 07:10:17 AM »
Anyone got suggestions on a seat bucket ?  My current set up is a 2mm aluminium base and 1mm seat back dzus'd and rolled over the top rail.   The seat "works" as is, however unless sitting bolt upright, it doesn't support my lower back.  It fits the car but is far from ergonomic ?
Logged

Offline Van

  • Full Member
  • ***
  • Posts: 116
    • View Profile
  • Your Best Time: 7.11 @ 189 with this car
  • Your Engine: Lincoln blown alky 534
  • Your Track: Bakersfield Ca.
  • Your Vehicle: Dragster
  • General Location: west coast
Re: Seat Buckets / Pans
« Reply #1 on: October 08, 2014, 08:40:45 AM »
You could do a pour in expanding foam liner, the kits are for just this type of fix.
Logged

Offline gregm784

  • Sr. Member
  • ****
  • Posts: 384
    • View Profile
    • Means Racing
  • Your Engine: 365" GenIV SBC
  • Your Track: Famoso Raceway
  • Your Vehicle: 1997 Stirling 200" FED
Re: Seat Buckets / Pans
« Reply #2 on: October 08, 2014, 09:29:07 AM »
Yup, time to pour a seat.

Or gain a lot of weight. :)
Logged
Greg
El Dorado County, CA
www.meansracing.com

Offline BK

  • Sr. Member
  • ****
  • Posts: 310
    • View Profile
  • Your Best Time: 8.45 / 5.30
  • Your Track: Empire Dagway
  • Your Vehicle: Late 70's FED
Re: Seat Buckets / Pans
« Reply #3 on: October 08, 2014, 09:53:04 AM »
 I had similar issue. But my car has a seat cover. I used a fairly dense foam and a sharp knife. Carved up some pieces to support my lower back. And tucked them behind the cover.
Logged

Offline dusterdave173

  • Hero Member
  • *****
  • Posts: 638
    • View Profile
  • Your Best Time: 5.38in 1/8th
  • Your Engine: 355 CI SBC
  • Your Track: Mooresville, NC
  • Your Vehicle: CenPen 200 inch FED
Re: Seat Buckets / Pans
« Reply #4 on: October 08, 2014, 01:13:22 PM »
I poured a seat bottom and it was best thing I ever did--car is super comfortable--great part is I bought way too big a por kit and now have more than enough fopr another seat bottom--call me I will give you a deal on it!! 704 244 6649
I made my bottom from .125 thick, then normal seat pan, then poured bottom--I love it!
Logged
I have always had a fascination with fast cars at the expense of more normal character development
Pages: [1]   Go Up
« previous next »