Technical > Roo Man's Room
Which center section?
JeffV8:
Until you mentioned it I didn't realize I didn't say mopar. But like you anyone in the mopar rear ends know what I was asking lol
slingshot383:
If you need a new pig, look into the aluminum one that Mopar Performance sell. It's based on the 742 case, and is lighter. Is your 8 3/4 a full floater? The one in my Woody car was, lots of fun finding the bearings and seals.
George:
I have been putting the iron 742 to the test in our 1700# blown SBC FED. Last time out went 4.61,4.59,4.59 with two .99 60' ( 1/8 mile). Leaving off the trans. brake at 5400 . If there were more season left I would replace the 12 X 33 with some 14". Probably build a Ford 9" for the car this winter.
Navigation
[0] Message Index
[*] Previous page
Go to full version