Drag Racing Discussions > Front Engine Dragsters

To Drill or Not to Drill

(1/2) > >>

jspell:
New wheels (non-bead loc) tubeless slicks.  How many screws is sufficient per side of the wheel? Eight per side?  Also, should you pre-drill wheels prior to slick mounting or would this create problems with bead sealing to inflate? 

masracingtd1167:
John you can pre drill them with no problem . 8 per side is just fine .

Gold Digger:
yes Pre Drill and deburr holes

GlennLever:

--- Quote from: Gold Digger on August 21, 2014, 05:41:36 PM ---yes Pre Drill and deburr holes

--- End quote ---

x2 ^

PSweeney:
I use some grease and run a sacrificial screw into each hole to tap it first. 

Navigation

[0] Message Index

[#] Next page