Technical > Roo Man's Room
6061-T651
(1/1)
George:
I ordered a piece of aluminum 6061-T6 for a new mid plate and it is 6061-T651. I have looked online and don't think there is a problem but it's something I haven't seen before. Any problems associated with this material?
Thank You. George
dreracecar:
To get to the -T6 temper, the 6061 is heated to about 990F, then quenched in water, then aged at about 350F for around 8 hours. That changes the typical yield strength from 8 ksi to about 40 ksi- fairly substantial.
But that quenching in water puts residual stresses in the aluminum, since there is a surface-to-center cooling gradient. The -T651 designation means the mill took that extrusion and gave it a 1% to 3% stretching, or permanent set, to get rid of some of those residual stresses.
George:
--- Quote from: dreracecar on August 06, 2014, 12:04:17 PM ---To get to the -T6 temper, the 6061 is heated to about 990F, then quenched in water, then aged at about 350F for around 8 hours. That changes the typical yield strength from 8 ksi to about 40 ksi- fairly substantial.
But that quenching in water puts residual stresses in the aluminum, since there is a surface-to-center cooling gradient. The -T651 designation means the mill took that extrusion and gave it a 1% to 3% stretching, or permanent set, to get rid of some of those residual stresses.
--- End quote ---
Thanks Bruce. It all sounds good to me.
Nightmare AA/FA:
--- Quote from: dreracecar on August 06, 2014, 12:04:17 PM ---To get to the -T6 temper, the 6061 is heated to about 990F, then quenched in water, then aged at about 350F for around 8 hours. That changes the typical yield strength from 8 ksi to about 40 ksi- fairly substantial.
But that quenching in water puts residual stresses in the aluminum, since there is a surface-to-center cooling gradient. The -T651 designation means the mill took that extrusion and gave it a 1% to 3% stretching, or permanent set, to get rid of some of those residual stresses.
--- End quote ---
Now there's a guy who knows his metal.
dreracecar:
Also how to copy and paste
Navigation
[0] Message Index
Go to full version