« previous next »
Pages: [1]   Go Down

Author Topic: Is 3/16" coupler movement too much?  (Read 5253 times)

Offline imcamod17

  • Newbie
  • *
  • Posts: 17
    • View Profile
  • Your Track: Muncie Dragway
  • Your Vehicle: 200" Hal Canode FED
Is 3/16" coupler movement too much?
« on: July 22, 2014, 10:14:45 PM »
I have 3/16" front to back play on my coupler. Should I put a bigger spacer or is that ok. I cut off a piece of a broom handle and installed it in the coupler before I slid it over the tranny tail shaft. The manufacturer suggested 1/8". I just want to be safe. I read it is for chassis flex.
Logged

dreracecar

  • Guest
Re: Is 3/16" coupler movement too much?
« Reply #1 on: July 23, 2014, 08:04:51 AM »
No worrys
Logged

Offline imcamod17

  • Newbie
  • *
  • Posts: 17
    • View Profile
  • Your Track: Muncie Dragway
  • Your Vehicle: 200" Hal Canode FED
Re: Is 3/16" coupler movement too much?
« Reply #2 on: July 23, 2014, 07:01:00 PM »
Copy that so 3/16" is good to go. Thank you
Logged

Offline cj92345

  • Newbie
  • *
  • Posts: 13
    • View Profile
  • Your Engine: 350
  • Your Track: fontana
  • Your Vehicle: 1964 britting
Re: Is 3/16" coupler movement too much?
« Reply #3 on: July 25, 2014, 11:58:50 AM »
mines got a shock absorber bushing in it
Logged

Offline imcamod17

  • Newbie
  • *
  • Posts: 17
    • View Profile
  • Your Track: Muncie Dragway
  • Your Vehicle: 200" Hal Canode FED
Re: Is 3/16" coupler movement too much?
« Reply #4 on: July 26, 2014, 04:08:30 AM »
cj92345 just curious where you got the shock absorber bushing? Do you cut it to fit?
Logged

Offline cj92345

  • Newbie
  • *
  • Posts: 13
    • View Profile
  • Your Engine: 350
  • Your Track: fontana
  • Your Vehicle: 1964 britting
Re: Is 3/16" coupler movement too much?
« Reply #5 on: July 31, 2014, 09:24:02 AM »
no trimming, just a old shock bushing from the top of a stud type mounting...gives it a little cushion.
Logged
Pages: [1]   Go Up
« previous next »