Technical > Spud Miller's Cave

scott super slot injector

<< < (5/5)

dreracecar:
Anything can be done, its a matter of cost -availability-fit.
Using current parts on a old casting, and the ability to get the basic set up/nozzles and lines fits those issues with the least amount of effort and cost.
Enderle will not work because of size and shape plus fitting placement, so it will have to be placed really off to one side and look like crap
Enderle "K" valve is expensive, and have extra ports and checks that wont be used.
Crower (RONS FI) is pricey and one still has to adapt.
My way starts with new parts from that era that a racer could have done that conversion back then.

DeSoto:
I will have a little more time after work to go over all your post. I kind of quickly skimmed them for now. I do like the sound doing this in a way that could have been done back in the day.
  I have a Joe hunt magneto  that stands up 3 1/2" higher than usual and is very close to the blower case. Less than a 1/2" clearance.  A hilborn right angle pump drive is the reason for this extra height. I can use this drive to run the pump if needed. If I take the angle drive out I would have to change to a longer shaft in the magneto to reach the gear.

DeSoto:
Another thing I should have mentioned is my blower manifold is not finished yet so if I needed a little more height in the rear to keep things off the magneto I could raise the blower a bit. I was trying to keep it as low as possible but if room is needed.

Navigation

[0] Message Index

[*] Previous page