« previous next »
Pages: [1]   Go Down

Author Topic: SBC Zoomies  (Read 5711 times)

Offline PSweeney

  • Full Member
  • ***
  • Posts: 231
    • View Profile
  • Your Track: Santa Pod
  • Your Vehicle: 138in SBC slingshot
SBC Zoomies
« on: June 15, 2014, 01:45:45 PM »
I'm having  a hard time getting 2" tubes positioned properly on a Stahl flange.  I want short tubes, and tight turns but the centre ports are limiting the amount I can lay the tubes back, about 80 degrees is max.  Any advice on how to position the tubes, or which radius to use to get them raked back ?
Logged

Offline rooman

  • Hero Member
  • *****
  • Posts: 559
    • View Profile
  • Your Best Time: 6.200/222.05 (1/4 mile--NT/F)
Re: SBC Zoomies
« Reply #1 on: June 15, 2014, 03:31:55 PM »
Phil, the only way to get a lot of lay back with a small block (or anything else with paired center ports) is to run the forward pipe around the outside of the second one.

Roo
Logged
Yeah, I am from the south--any further south and I would have been a bloody penguin.

Offline PSweeney

  • Full Member
  • ***
  • Posts: 231
    • View Profile
  • Your Track: Santa Pod
  • Your Vehicle: 138in SBC slingshot
Re: SBC Zoomies
« Reply #2 on: June 25, 2014, 06:24:24 AM »
thanks Roo, not sure how I'm gonna get round this one, I read somewhere bending each tube 3 degrees more and increasing the pipes length at the head towards the back should line them up so they can lay over ?
Logged

Offline Paul New

  • Hero Member
  • *****
  • Posts: 743
    • View Profile
  • Your Best Time: 6.47 @ 214 MPH SBC
  • Your Engine: 387" SBC
  • Your Track: Woodburn Dragstrip
  • Your Vehicle: 2005 FED
Re: SBC Zoomies
« Reply #3 on: June 25, 2014, 09:45:22 AM »
Here are some I built granted they have pipes that start in the radius no straight section coming out of the flange hard to see in this pic but it is the only one I have on my phone
Logged

Offline retroboy

  • Full Member
  • ***
  • Posts: 221
    • View Profile
  • Your Track: Whyalla
  • Your Vehicle: FED
Re: SBC Zoomies
« Reply #4 on: July 20, 2014, 12:03:48 AM »
Hey Phil. These are some I've just done for SBM as Roo suggested. These pipes are 15" long are an 80 degree bend.
Cheers
Tony

Logged
Pages: [1]   Go Up
« previous next »