Author Topic: Holes Through Motor Plate.  (Read 3788 times)

Offline grapro

  • Jr. Member
  • **
  • Posts: 71
    • View Profile
  • Your Track: edmonton
  • Your Vehicle: 184" FED
Holes Through Motor Plate.
« on: June 23, 2014, 05:41:33 AM »
I was wondering what guys where doing when running lines such as tranny coolers or wires and cables through the rear engine plate. I have holes through my uprights but they will not be enough to service everything. Do you use bulkhead fittings or is there something else?

Offline wideopen231

  • Hero Member
  • *****
  • Posts: 1911
    • View Profile
  • Your Best Time: 1/8 3.70@ 198 1/4 5.78@245
  • Your Engine: Hemi 526 ci alcohol
  • Your Track: Piedmont
  • Your Vehicle: 225 CMC FED
  • General Location: NORTH CAROLINA
Re: Holes Through Motor Plate.
« Reply #1 on: June 23, 2014, 07:21:36 AM »
I have hole in lower frame rail for cpl things to pass thru. I welded a tube type reinforcement around it and did the same at the exit hole in front of the engine. I also have passages thru both uprights. I don't like passing anything thru motorplate,it makes removal lot more work IMO.
Relecting obama is like shooting right foot because it did not hurt enough when you shot left foot